Install Magcore - RBC Bioscience MagCore HF48 Operation Manual

━ Install MagCore

Please refer to the position reference shown on page 5, locate the
system in an appropriate place, put down the four fixed stands for
fine-tuning according to the ground level, and tighten fixed screws
Next Step
1
Rotate and pull out the fixed bolts on both sides of the top cover of
part chamber by coins
Next Step
Open the top cover of part chamber by using the fixed bolts on the
top cover of part chamber as holders
Please note the weight of the top
cover of part chamber. The step may
need two people to accomplish.
Next Step
Shear the transportation belt and return the top cover of part
chamber
Next Step
2
Shear the belts on Racks
Next Step
Plug the power cord and turn on the main power
Make sure that the voltage of
the outlet is 220V ~ 240V. Keep
hands dry. Also, make sure that
the machine remains off, and
insert the plug and then turn on
the power switch.
Next Step
Turn on the power (red) and the system will be initialized
automatically
!
Please set the local time (refer to
page 19) for the first installation, and
perform test according to "Piston
Test" (page 15)..
Please finish reading the operation
manual before any operation!
MagCore® HF48
6