Tv Only - Sony SAT-A2 Operating Instructions (primary manual) Operating Instructions Manual

TV Only

TV With RF Connector Only
Some TVs label this jack RF IN,
instead of VHF/UHF IN.
1
SAT-A2 receiver is pictured, but connections
are identical for SAT-B2.
12
Chapter 3: Connecting Your System
Refer to the illustration below (SAT-A2 receiver is pictured).
1
Connect the RG-6 cable from the satellite antenna's LNB to the DSS
receiver's SATELLITE IN jack.
2
Connect the DSS receiver's VHF(SAT)/UHF OUT jack to the TV's
VHF/UHF IN jack.
Note
A VHF/UHF connection does not provide stereo sound. To receive stereo
sound, you must use an A/V connection (described on page 13).
3
Connect one end of the telephone line cord to the DSS receiver's
TEL LINE jack. Connect the other end to your home's modular
telephone outlet.
4
Connect one end of the AC power cord to the DSS receiver's AC IN
jack. Connect the plug end to an AC outlet.
Optional Connections
If you have a cable input, cable box, or a terrestrial TV antenna,
connect it to the DSS receiver's VHF/UHF IN jack.
To connect the DSS receiver to your audio system, use audio cables
to connect the DSS receiver to your audio receiver's AUDIO IN
jacks.
2 3 4