Start Up; Pairing In.touch 2-Co (Spa) And In.touch 2-En (Home) - TechBook in.touch 2 Manual

Start up

Pairing in.touch 2-CO (spa) and in.touch 2-EN (home)

The pairing process is used when you need to replace one module of the in�touch 2 kit� Otherwise, the in�touch 2 arrives
pre-paired from the factory�
1� Power up the in�touch 2-EN module
2� Press on the pairing button with a paper clip or some
similar tool� When the pairing mode is active the status
LED flashes YELLOW in a rapid pattern� The in�touch
2-EN is then in pairing mode and will remain in this
mode until it pairs with an in�touch 2-CO module,
or until it is reset (power cycled)�
Note: in�touch 2 modules can be paired as often as necessary, but can only be paired with a single counterpart module
at a time� Once paired, the modules store this information permanently until the next pairing operation� Pairing informa-
tion is stored in non-volatile memory, so pairing is not required after a power failure� Only an in�touch 2-EN module can
initiate a pairing, so it is important that the pairing begin with putting the in�touch 2-EN module in pairing mode�
If several spas are powered up at the same time with an in�touch 2-EN module in pairing mode (for instance, in a dealer
showroom), only the 1st spa to successfully connect to the in�touch 2-EN will pair� As this can be random, it is recom-
mended that only 1 spa be powered up at a time during the pairing process�
8
pairing button
status LED
3� Shut off the spa's breaker (thus turning off the
in�touch 2-CO module), wait a few seconds, and
then flip the breaker back on� Within a few seconds,
the pairing operation should complete and the
in�touch 2-EN status LED will no longer be YELLOW�
Main electrical box GFCI panel