Connection Of The In.touch 2-Co (Spa) - TechBook in.touch 2 Manual

Installation and connections

Connection of the in.touch 2-CO (spa)

Simply connect the in�touch 2-CO module into an available CO port of the spa pack (or any other accessory with a free
CO port, such as the in�stream 2 audio amplifier, or the in�clear spa sanitizing system)�
Note that the in�touch 2-CO only has a single CO cable and thus must be installed at the end of the CO chain if more
than a single accessory is installed on the same CO port of the spa pack�
Note: Before powering up the spa pack again, please go to the next step and install the in�touch2-EN module�
CO port
CO port
6