Table of Contents
Advertisement
Installation and connections
in.touch 2-CO (spa) installation
Before proceeding with any installation, be sure to turn spa power off�
The in�touch 2-CO unit must be installed under the spa skirt, at least 12" (30 cm) away from any metal component or
structure� This is necessary to ensure optimal transmission� In some cases, it may be necessary to relocate the unit once
the spa is installed in the yard to ensure proper signal transmission and distance�
Install the in�touch 2-CO so the module can be repositioned to optimize the signal strength in the yard (it is possible to
see the signal strength with the in�touch 2 application in the menu Setting -> in�touch network -> Signal strength)�
We recommend that you install the unit with a #8 pan head screw�
Here are some suggestions for a successful installation:
• Install the unit as high as possible within the spa skirt, but keep it away from the spa frame if it is metallic�
• Route the cable and leave some slack in the in�touch 2-CO cable so the in�touch 2-CO can be moved around in case
of reception problems�
• Install the in�touch 2-CO in a corner of the spa to help avoid metallic components, accessories and piping close to the
in�touch 2-CO�
• The in�touch 2-CO module should be installed as close as possible to the house to optimize signal strength� It is
recommended to install the in�touch 2 module on the side of the spa facing the house to increase the signal� A body of
water between the in�touch 2-CO module and the in�touch 2-EN will reduce the signal strength�
LD
5
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the in.touch 2 and is the answer not in the manual?