In.touch 2-Co (Spa) Status Led - TechBook in.touch 2 Manual

Troubleshooting

in.touch 2-CO (spa) status LED

This module's LED can show various status conditions, as shown below�
Rapidly flashing YELLOW color :
The in�touch 2-CO is in pairing mode when this color is
shown� This normally briefly occurs automatically during
power-up of the spa (i�e� right after the breaker is flipped
on)� This could also occur if the in�touch 2-CO was never
paired (which is very unlikely, as they are shipped paired
from factory)� Refer to the pairing section if your unit has
not been paired, so you may complete the process�
BLUE color :
Reason?
This is the normal state of the in�touch2-CO LED� If the
in�touch 2-EN module also shows solid blue, you are
all set! If this LED is blinking, refer to the Blinking LED
section below�
What to do?
Enjoy your spa!
22
Blinking LED :
On both modules, if the LED is blinking about once per
second, it means that the RF link is not established
between them (i�e� each in�touch 2 module cannot
communicate with its counterpart)� This can occur for
several reasons�
Review the following and perform the tests in the order
given below�
Unpaired:
As the modules are shipped paired from the factory, this is
not a likely cause, but it is the easiest test to perform in the
field� Simply attempt to pair them again� Please refer to the
Pairing section for instructions on pairing�
Modules out of range:
If the pairing test above does not resolve the problem,
then the modules may be too far from each other for an
effective RF link� To test this, simply connect the in�touch
2-EN outside, close to the spa (via an extension cord for
power)�
A router connection is not needed for this test� If the
module LEDs no longer blink, an RF link was established
which confirms the hypothesis that the modules were too
far apart� Getting the modules closer together somehow is
the only solution�
If moving the modules closer together does not stop the
LEDs from blinking, attempt to pair them again� If this
pairing fails even though the RF modules are near each
other, then one or both of the modules are defective,
replace them�