Table of Contents
Advertisement
C
ROSSING THE
If the panel goes across the entry step:
1.
With the panel attached to the RV
wall, carefully mark the location of
the top, side edges of the step.
2.
Remove the skirt from the RV and
lay on a flat clean surface.
3.
Measure the height of the step.
4.
On the skirt, measure and cut a 1/2"
slot from the marks made in step 1.
the slot should be the height of the
step + 1/2"
5.
Draw and cut a straight line between
the bottoms of the slots. This creates a
flap in the fabric.
6.
Slide the skirting over the step and
tuck the flap behind the stair tread.
Attach the skirting to the skirt clips.
7.
After hanging the skirting, fold any
excess material under the vehicle
and stake as desired.
C
ROSSING THE
If the skirting is mounted at the floor line or raised to avoid obstacles the skirting
may cross over the door. Simply mark the sides of the door and trim the material
vertically on each side. Fold the excess material behind the panel.
E
S
NTRY
TEP
D
OOR
Completed Skirt
Outer Edge
of Step
Top of Step
Step Height
Outer Edge
of Step
Top of Step
Step Height + 1/2"
V
'
ACATION
R
Outer Edge
of Step
Outer Edge
of Step
1/2"
we005
we006
11
Advertisement
Table of Contents
