Omron H7CZ-L8 Manual page 15

UP
Reset
999999
Set value
P
0
OUT
Reset
999999
Output
Set value
mode
Q
setting
0
OUT
Reset
999999
Set value
A
0
OUT
Note: 1. When the present value reaches 999999, it returns to 0.
2. Counting cannot be performed during reset input.
3. If reset is input while one-shot output is ON, one-shot output turns OFF.
4. If there is power failure while output is ON, output will turn ON again when the power supply has recovered.
For one-shot output, output will turn ON again for the duration of the output time setting once the power supply has recovered.
5. Do not use the counter function in applications where the count may be completed (again) while one-shot output is ON.
6. The setting range is 0 to 999,999.
Input mode
DOWN
(The one-shot output time can be
set in the range 0.01 to 99.99s.)
Self-holding One-shot
output
Operation after
count completion
The present value
display does not
change during the
one-shot output time
period, but the actual
count returns to the
reset start status.
The output will return
to one-shot mode.
The outputs repeat
one-shot operation.
The present value
continues to increase/
decrease for the one-
shot output time, but
returns to the reset
start status after the
one-shot output time
has elapsed.
The outputs repeat
one-shot operation.
The present value
display and OUT self-
holding output is held
until reset is input.
H7CZ
15