GE Amersham Typhoon Operating Instructions Manual page 100

6 Operation
6.1 Preparing the Amersham Typhoon scanner
6.1.2 Changing the filters
Place the filter module in the
scanner
Step
5
6
7
100
Action
Insert the filter module in the filter module holder. A clicking sound indicates
that the filter holder is in the correct position.
Close the filter door.
In the Amersham Typhoon Control Software, check the list of filters in the
Instrument status pane. Make sure that the newly installed filters are cor-
rectly registered.
Note:
The filters are recognized automatically. Custom filters are designated Cus-
tom1 and Custom2 in the control software. In case the scanner does not
automatically recognizes a filter, or identifies a filter incorrectly, contact a GE
representative for service.
Amersham Typhoon Operating Instructions 29193226 AC