Installing Imagedirector - Sony VPL-VW12HT Image Director Operating Instructions Manual

Preparations
Pin assignment for D-sub 9-pin and D-sub 25-pin
connectors are as follows.
D-sub D-sub
9-pin 25-pin
1 8 DCD Data Channel Signal Carrier Detect
2 3 RxD Received Data
3 2 TxD Transmitted data
4 20 DTR Data Terminal Ready
5 7 SG Signal Ground (GND)
6 6 DSR Data Set Ready
7 4 RTS Request to Send
8 5 CTS Clear to Send
9 22 RI Ring Indicator (Ringing or no ringing)
Shell = FG 1 FG Frame Ground or cable shielding
Notes
• On the D-sub 25-pin connector, all pins not assigned
are reserved for future use.
• Longest guaranteed cable length: 15 meters (49 feet
2 inches) (However, even under 15 meters (49 feet 2
inches), depending on the cable used, operation
cannot be guaranteed.)
2
After turning the projector on, turn on the
computer.

Installing ImageDirector

Complete the following procedure to install
ImageDirector.
1
Insert the ImgD_100 CD-ROM in the computer's
CD-ROM drive.
2
Double click "My Computer," select the CD-
ROM icon, then select [Open] from the Right
click menu.
The contents of the CD-ROM are displayed.
(The display may differ, depending on your computer and its
OS.)
4
(GB)
Designation
3
Copy the "ImageDirector" folder to the directory
of your choice on your computer.
To uninstall ImageDirector
Delete the "ImageDirector" folder you copied from the
CD-ROM to your computer.
Note
If you intend to uninstall ImageDirector after using it
to adjust the projector's gamma value, be sure to
return the projector's gamma value to the factory
setting before uninstalling the software (Reset). If you
uninstall the software without resetting the gamma
value, you won't be able to reset the value afterwards.
For more details on resetting the gamma value, see
"Returning the Projector's Gamma Value to the Factory
Setting (Reset)," on page 8 (GB).