Switching Off With A Timer; Child Safety Lock; Cleaning - Silvercrest SIKP 2000 B1 Operating Instructions Manual

__RP100060_Induktionskochplatte_B4.book Seite 8 Donnerstag, 13. Februar 2014 11:50 11
carries on cooling the appliance after it
has been switched off.
• After 120 minutes without a change in
setting, the appliance switches off auto-
matically. The cooling fan carries on
cooling the appliance after it has been
switched off.
8.3 Switching off with a
timer
1. Touch the symbol 9 during operation.
The control light 13 lights up, min ap-
pears above the display and on the dis-
play the chosen switch-off time appears
in minutes (presetting: 0 minutes, the de-
vice remains on).
2. Change the switch-off time by touching
the symbol 8 in one-minute steps and
by touching the symbol
ute steps. If you have set the chosen time
and touch no further symbols, the timer
starts automatically and the display
switches over to W or °C again. At
short intervals, the remaining time is dis-
played together with min.
3. After the preset time has elapsed, the
appliance switches off. An acoustic sig-
nal sounds. The symbol -H- is shown in
the display, as the temperature of the
cooking zone is more than 60 °C. The
cooling fan carries on cooling the appli-
ance after it has been switched off.

8.4 Child safety lock

To prevent unwanted alteration of the set-
tings, the appliance is equipped with a child
safety lock.
NOTE: if the child safety lock is activated
while in operation, the symbols child safety
lock 6 and on/off
and you can switch the device off. You will
8
GB
only be able to switch the device on, once
the child safety lock has been deactivated.
• Touch the symbol child safety lock
• Touch the symbol child safety lock

9. Cleaning

7 in 10-min-
• Pull the mains plug 1 out of the wall
• The induction hot plate, the power ca-
WARNING! Risk of material damage!
• Do not use any astringent or abrasive
• Clean the cooking zone 2 after every
• Clean all surfaces and the power ca-
• Baked-on residues on the cooking
5 are not blocked
The control light for the child safety
lock 3 lights up and an acoustic signal
sounds. All symbols except the child
safety lock 6 are now blocked.
for at least 4 seconds to override the
child safety lock. An acoustic signal
sounds and the control light for the child
safety lock 3 goes out. The symbols are
no longer blocked.
DANGER! Risk of electric shock!
socket before you clean the device.
ble 1 and the mains plug 1 must not be
immersed in water or any other liquids.
DANGER! Risk of injury
through burning!
Allow the device to cool down be-
fore cleaning.
cleaning agents.
use. In this way, you can prevent any ad-
hering food residues from burning on.
ble 1 with a slightly moistened cloth.
zone 2 can be removed with a ceramic
hob scraper, which may be purchased
at a department store.
6.
6