2 Safety instructions • The device described is a subcomponent for integration into a system� - The manufacturer of the system is responsible for the safety of the system� - The system manufacturer undertakes to perform a risk assessment and to create a documentation in accordance with legal and normative requirements to be provided to the operator and user of the system�...
The IODDs necessary for the configuration of the unit, detailed information about process data structure, diagnostic information, parameter addresses and the necessary information about the required IO-Link hardware and software can be found at www�ifm�com� 5 Installation ► Connect the unit to a temperature probe�...
6 Electrical connection The unit must be connected by a qualified electrician� The national and international regulations for the installation of electrical equipment must be adhered to� Voltage supply to EN 50178, SELV, PELV� ► Disconnect power� ► Connect the unit as follows: IO-Link LED2 LED1...
7 Parameter setting Using an IO-Link capable parameter setting tool, the following options are available: - Reading current process values� - Reading, changing and saving current parameter settings and transmitting them to other units of the same type� 7.1 Adjustable parameters Output function for OUT2: Analogue signal: 4���20 mA [I] or 20���4 mA [Ineg]�...
- falls to min. 3.8 mA (at [OU2] = [Ineg]). Value below or above the Analogue signal acc� to setting [FOU2]� detection zone of the sensor 9 Technical data and scale drawing Technical data and scale drawing at www�ifm�com� 10 Factory setting Factory setting User setting TP3231...