Maintenance And Cleaning; Environmental Instructions And Disposal Information; Information About Warranty And Service Processing - Parkside PISG 80 A2 Assembly, Operating And Safety Instructions, Translation Of The Original Instructions

... / Maintenance ... / Environmental instructions ... / Information about warranty ...
Weld penetration
Weld width
Welding bead
Weld imperfections
Note: Determine which welding method is more
suitable for yourself after welding a test piece.
Note:
Once it has worn down completely,
the electrode must be replaced.

Maintenance and Cleaning

Note: The welding tool requires regular maintenance
and reconditioning to work properly and to comply
with safety requirements. Improper and incorrect
operation may result in malfunctions and damage
the tool.
Before performing maintenance work or
repairs on the welding tool, disconnect the
10
power cable
the tool is safely isolated from the power supply.
Clean the exterior of the welding tool regularly.
Use compressed air, cotton waste or a brush
to remove dirt and dust.
Note:
The following kinds of maintenance work
must be performed only by suitably-qualified
personnel.
Current regulators, earthing equipment, internal
cables, the blowpipe coupler and adjusting
screw should be maintained regularly. Tighten
loose screws and replace rusty screws.
(M4 × 10 replacement screws are available
from your local DIY store.)
281479_Inverter Schweissgeraet PISG 80 A1_content_IT_PT.indd 43
Towards the unwelded
part:
from the power outlet to ensure
Towards the welded part:
less
larger
flatter
greater
Regularly check the leakage resistance of the
welding tool. Use suitable measuring instruments
for this purpose.
In the event of a defect or if components need
to be replaced, please contact the correspond
ing professional.
Environmental instructions
and disposal information
Don't waste,
recycle!
Device, accessories and packaging
-
should be recycled in an environmen-
tally friendly manner.
Do not dispose of the inverter welder equipment with
your household waste, or throw into fire or water. If
possible, non-operational equipment should be re
cycled. Contact your local retailer for information.
Information about warranty
and service processing
Creative Marketing Consulting GmbH
-
warranty
greater
smaller
higher
less
-
GB 43
28.12.16 12:20