Introduction; Intended Use; Features; Package Contents - Parkside PDS 290 C3 Translation Of The Original Instructions

DELTA SANDER PDS 290 C3

Introduction

Congratulations on the purchase of your new appli-
ance . You have chosen a high-quality product . The
operating instructions are part of this product . They
contain important information about safety, usage
and disposal . Before using the product, please
familiarise yourself with all operating and safety
instructions . Use the product only as described and
for the range of applications specified . Please also
pass these operating instructions on to any future
owner .

Intended use

Depending on the sandpaper being used, this
appliance is suitable for the dry sanding of wood,
plastic, metal, filler and also painted surfaces .
The appliance is particularly suitable for corners,
edges and hard-to-reach areas . Any other usage of
or modification to the appliance is deemed to be
improper and carries a significant risk of accidents .
The manufacturer accepts no responsibility for
damage(s) resulting from improper usage . This ap-
pliance is not intended for commercial use .

Features

ON/OFF switch
Speed adjustment wheel
Power cord
Extraction nozzle
Air vents
Sanding plate (360° rotation)
Adapter for dust extraction
Reducer
Sanding sheet
■ 2 │ GB │ IE │ NI │ CY

Package contents

1 delta sander PDS 290 C3
3 sanding sheets
1 adapter for dust extraction
1 reducer
1 set of operating instructions

Technical data

Rated power
consumption:
Rated voltage:
(AC)
Rated idle speed:
Rated no-load
oscillation speed:
Sanding plate:
Protection class:
Noise emission value:
Noise measurement value determined in accor-
dance with EN 62841 . The A-rated noise level of
the power tool is typically as follows:
Sound pressure level L
PA
Uncertainty K :
pA
Sound power level L
WA
Uncertainty K :
WA
Wear hearing protection!
Vibration emission value:
Vibration values (vector total of three directions)
determined in accordance with EN 62841:
Vibration emission value a
Uncertainty K = 1 .5 m/s
NOTE
► The total vibration value and the stated noise
emission values specified in these instructions
have been measured in accordance with a
standardised measuring procedure and can
be used to make equipment comparisons . The
specified total vibration value and the noise
emission values can also be used to make an
initial exposure estimate .
290 W
230 V ∼ 50 Hz
n 6000–11000 rpm
0
n 12000–22000 rpm
0
360° rotation
II / (double insulation)
: 82 dB (A)
3 dB
: 93 dB (A)
3 dB
= 8 .2 m/s
2
h
2
PDS 290 C3