Trouble Shooting - FLORABEST FLB 2500 A1 Translation Of Original Operation Manual

Trouble shooting

Problem
Device does not
start
Device works with
interruptions
Low suction capacity
or suction not pres-
ent
Small or missing
blowing power
Device works with
interruptions
Possible cause
Mains voltage is not pres-
ent
Defective on/off switch
Worn carbon brushes
Defective motor
Blowing/suction pipe (2) is
not completely fitted
Impeller wheel cover still
open (see No. 25)
D
Damaged power cable
Internal loose connection
Defective on/off switch
Collection bag (18) is full
Collection bag is dirty
Selector switch (16) in in-
correct position
Device clogged up or
blocked by foreign bodies
Selector switch (16) in in-
correct position
Airstream regulator (10) in
incorrect position
Foreign body blocks impel-
ler wheel
Fault correction
Check plug socket, cable, line,
plug and fuse, where appropriate,
repair through electrical specialist
Repair through customer service
Install a two-part blowing/suction
pipe
Close impeller wheel cover and
screw it down properly
Check cable; where appropriate,
replace
Repair through customer service
Empty collection bag
Clean collection bag
Set selector switch to the
suction symbol
Remove plug or blockages (see
chapter Cleaning and Mainte-
nance)
Set selector switch to the
blowing symbol
Rotate airstream regulator to high
position
Remove blockage (see chapter
Cleaning and Maintenance)
GB CY
15