Advertisement
Section
III
M o d e l DRC-93C
2.
While holding in the
CURVE#
key,
A1, A2, A3, and A4 all use the Curve
press the REM (REMote) key.
Number from the A column of the
Release the
CURVE#
key.
correlation table.
3 .
Now press the
(Up) key to tog-
3 . 9 . 2 . 3
Modifying
the Correlation
gle the Upper Display External
T a b l e
from
the Front Panel
curve select ion.
The REMOTE
POSITION DATA will appear in the
The DRC-93C is shipped from the
GAIN windows to indicate that the
factory with curve 02 stored in all
REMOTE POSITION DATA will be used
positions of the Correlation Table.
for curve selection by the Upper
Display Sensor.
Hitting the
The Correlation Table is modified by
key
again will blank the GAIN
using the
CURVE#
and
key and
window indicating that the REMOTE
POSITION DATA will not be used.
The operation is the same for the
1 .
Use the procedure described in
key except that the Lower
the previous section to put the
Display Sensor and RESET window
instrument in the External Scan-
are involved.
ner mode.
4.
When the desired condition is
2.
Apply a signal on the REMOTE
SEN-
reached, release all keys.
SOR ID Connector to indicate a
position
number
,
the
REMOTE
3 . 9 . 2 . 2
The Correlation
T a b l e
POSITION DATA.
This can be done
by
attaching a Scanner and
sel-
The
CURVE#
key will show that the
ecting a position.
External Scanner has been selected
by indicating the REMOTE POSITION
3.
Select the Curve Number desired
DATA in the GAIN window for the
for that position from the front
Upper and in the RESET window for
panel as described in section
the Lower Display.
The instrument
3 . 9 . 1 . 4 .
The GAIN or RESET win-
uses the REMOTE POSITION DATA (the
dow must have the REMOTE POSITION
signal applied to the REMOTE SENSOR
DATA to show that the function is
ID Connector from the Scanner) in
enabled.
conjunction with
the Correlation
Table of Table
3-4
to obtain the
4.
When the ENTER key is pressed,
Curve Number.
the Curve Number will be stored
in the Correlation Table in the
If the REMOTE POSITION DATA is zero,
Position indicated by the REMOTE
then instrument uses the same Curve
POSITION DATA in the GAIN window
Number assigned to the input without
if the Curve in the Upper Display
the Scanner.
When there is an
8229
was altered or in the RESET win-
Scanner option present, there are
5
dow if the Curve# in the Lower
Curve Number assignments for Input
Display was altered.
A--- one each for AO, A1,
A2,
A3, and
A4.
key as follows.
If the REMOTE POSITION DATA is non-
zero, then the Curve Number is
selected from the row of the Cor-
relation Table corresponding to the
value of the REMOTE POSITION DATA.
When there is an 8229 Scanner Option
present, there is only one Curve
Number assignment for Input A---A0
,
3-12
COPYRIGHT
3/88
Advertisement
