Table of Contents
Advertisement
8. USE OF EMG-USB2
EMG-USB2 CONFIGURATION
The embedded keypad and the display on the front panel of EMG-USB2, allow the operator to
change the settings of the amplifier as explained in the following instructions:
Using PREV. INPUT
Move the selection to the desired parameter using
Press
to confirm the parameter selection; only the parameter will be negative displayed to
indicate that it is possible to change the value of the selected parameter.
Scroll the available options and select the desired value using the
Press
to confirm the new value.
Selecting the option
possible to set additional parameters.
All the settings are send to the PC at the end of each acquisition and the settings are stored
together with the signals by OT BioLab. For further details refer to the OT BioLab user manual.
When the EMG-USB2 is switched off the settings are stored into an internal memory and are
reloaded when the instrument is switched on again.
A complete description of the parameters and settings can be found in the following sections.
Detection Mode
EMG-USB2 feature different detection modalities. The detection mode is displayed in the first line
of every input menu and is common to all the amplifier channels. In table 3 are listed and
described all the available options. To better understand how the different mode works, it is
important to remember that each input of the amplifier manages 16 signals (in case of IN 1÷4) or
64 signals (in case of MULTIPLE IN 1÷3) from the adapters. Each channel amplify the difference
between two signals.
and NEXT INPUT
Enter Set-Up
the instrument give access to the Set-Up menu where it is
keys it is possible to browse the inputs menu.
and
pag. 18/31
EMG-USB2 User manual
keys.
and
keys.
v.2.0
Advertisement
Table of Contents
