Two Vcrs For Tape Editing - Sony Grand WEGA KDF-E60A20 Operating Instructions Manual

Two VCRs for Tape
Editing
Using
S VIDEO jacks?
See page 18.
Cables are often
color-coded to connectors.
Connect red to red,
white to white, etc.
VCR (playback)
A/V cable (not supplied)
If you connect two VCRs, you can record from one VCR to the other while
using your TV to monitor what is being recorded.
Disconnect all power sources before making any connections.
1
Use A/V cables to connect the playback VCR's AUDIO and VIDEO
OUT jacks to the recording VCR's AUDIO and VIDEO IN jacks.
2
Use A/V cables to connect the recording VCR's AUDIO and VIDEO
OUT jacks to the TV's AUDIO and VIDEO IN jacks.
✍
To perform tape editing, set the TV to the video input intended for
playback by pressing TV/VIDEO on the remote control.
✍
You may need to change the video input on your VCR. Consult your
VCR's operating manual for instructions.
✍
If your VCRs have S VIDEO jacks: For best picture quality, use an
S VIDEO connection instead of the yellow video cable on your combined
A/V cable.
Use an S VIDEO cable to connect the playback VCR's S VIDEO OUT jack
to the recording VCR's S VIDEO IN jack. S VIDEO does not provide audio,
so audio cables must be connected to provide sound.
✍
You cannot record signals from equipment connected to the YP
Rear of TV
S VIDEO
VCR (recording)
VIDEO
L
(MONO)
AUDIO
AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
A/V cable (not supplied)
Connecting the TV
VIDEO IN
1 3
7
R
P input.
B R
35