Setting Up The Tv Channel List; Using Initial Setup - Sony Grand WEGA KDF-E60A20 Operating Instructions Manual

60" 3lcd rear projection television
Hide thumbs Also See for Grand WEGA KDF-E60A20:
Table of Contents

Advertisement

Connecting the TV

Setting Up the TV Channel List

Using Initial Setup

30
After you finish connecting the TV, you can run the Initial Setup to create a
list of available analog and digital channels. The Initial Setup screen appears
when you turn on the TV for the first time after hooking it up. If you choose
to set up the channels at a later time select the Auto Program option in the
Channel menu to scan available channels (see below).
The Auto Program feature does not apply for installations that use a
cable box for all channel selection.
To run Initial Setup the first time you turn on your TV
TV POWER
1
Press
to turn on the TV.
The Initial Setup screen appears.
2
Press V or v to highlight the on-screen
display language. Then press
message "First please connect cable/
antenna" appears. This may require 50+
minutes for completion and "Start auto program now?" appears.
3
Press V or v to highlight "Yes" then press
Auto Program performed through Initial Setup will automatically create a
list of receivable channels from both VHF/UHF antenna and cable TV
channels if both sources are connected.
Auto Program may take a while (20 to 50 minutes) to complete. A
progress bar is displayed while available channels are being scanned. If
you cancel the Auto Program before all receivable channels are scanned,
you may want to perform the task later (see "To run Auto Program at a
later time" below).
If you selected "No" during the Initial Setup, the Initial Setup message
will appear each time you turn on the TV until you complete the Auto
Program as a reminder.
To run Auto Program at a later time
1
Select Settings in WEGA GATE, and then go to Channel settings.
2
Select Auto Program then select Start.
Auto Program will create a list of receivable channels for the current
input (UHF/VHF antenna or CABLE). You will be required to run Auto
Program for each RF input to create a list of available channels from both
inputs.
. The
.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents