To Update The Equipment Touch's Firmware - Carrier Equipment Touch Installation And Setup Manual

To update the Equipment Touch's firmware

The Equipment Touch has a USB port at the bottom that allows you to update the device's firmware from a USB
flash drive.
PREREQUISITE The USB flash drive must be formatted as FAT, FAT16, or FAT32. To verify, right-click the flash
drive in Windows Explorer, then select Properties. File system should show FATxx. If File system shows NTFS or
anything else, you must reformat the drive. Right-click the flash drive, then select Format. In the File system field,
select FAT (Default), then click Start.
CAUTION Follow the steps below in order. If you select Reload Firmware (step 3) on the display before you
insert the USB drive (step 2), the touchscreen will become inoperable.
To update the firmware:
1
Create a folder on the flash drive called Touch, then put the ETxxxxxx.hex file in the folder.
2
Plug the flash drive into the Equipment Touch's USB port.
3
From the System screen, touch Setup > Touchscreen Setup > Reload Firmware.
4
A warning message appears. Touch Yes to continue.
5
The following series of messages appear:
Verifying Firmware Image.
Reading Firmware Image from USB.
Installing Application.
Verifying Firmware Image.
When the Home screen displays, remove the flash drive.
Equipment Touch
Installation and Setup Guide
To update the Equipment Touch's firmware
23
CARRIER CORPORATION ©2019
All rights reserved