Qadvanced Roller Shade
Gen. 3
Programming Instructions
During FIRST TIME SETUP after Step 3. TUG, a remote must be paired to the shade within 90 seconds. Otherwise, the shade
will time-out and require a Special Learn Command (Pg. 1) to pair a new remote. JOG is a short up and down movement.
Channel number is indicated on the remote by a single green LED. The "ALL" channel (all 5 green LEDs illuminated) follows
Channel 5 in the selection sequence. Shade will only respond to learned channel, or "ALL" channel.
FIRST TIME SETUP
1. INSTALL SHADE following appropriate instructions
2. PRESS and RELEASE the CHANNEL button to select a channel (1-5)
__
(Skip channel selection for Single-Channel Remotes)
3. TUG the HEMBAR 6-10 inches (Shade will JOG in response)
4. Use a paperclip to PRESS the PROGRAM button on the back of the remote
(The Channel LEDs will scroll back and forth when in program mode)
5. PRESS and RELEASE the UP button
__
(Shade will JOG, move to Upper Limit Position, then JOG again)
SETTING LOWER LIMIT
1. PRESS and RELEASE the DOWN button
__
(Shade will move to current Lower Limit Position)
2. PRESS and HOLD the DOWN button until shade JOGS
3. TUG the HEMBAR 6-10 inches (Shade will JOG in response)
4. ADJUST shade to desired Lower Limit
__
(The DOWN button is disabled while setting the Lower Limit, adjust by pressing the
___UP button or manually roll shade by hand)
5. PRESS and HOLD the DOWN button until shade JOGS
Use Special Learn Command when:
- The shade times-out without being paired to a remote.
- A paired remote is not being used or available
- Adding a second remote to the shade
SPECIAL LEARN COMMAND
(Shade at Upper Limit Position - manually roll shade up by hand if necessary)
1. Use a paperclip to PRESS the PROGRAM button on the back of the remote
(The channel LEDs will scroll back and forth when in program mode)
2. PRESS and HOLD the CHANNEL button until the shade moves
3. TUG the HEMBAR 6-10 inches
__
(The shade will JOG in response)
4. Use a paperclip to PRESS the PROGRAM button on the back of the remote
(The channel LEDs will scroll back and forth when in program mode)
5. PRESS and RELEASE the UP button
(Shade will JOG, move to Upper Limit Position, then JOG again)
Read and understand each section before performing required steps
www.qmotionshades.com
IMPORTANT
CHANNEL
Pensacola FL, 32514
UP
DOWN
CH
12345
Multi-Channel QdR Remote
UP
DOWN
Single-Channel QdR Remote
(Channel Numbers Not Labeled)
PROGRAM
Pin Hole
Remote Back
1 -877-849-6070
20%
40%
60%
80%
20%
40%
60%
80%
1
PN 9000217