Advertisement
Lower Limit Position must be set prior to using the PRESET positions (20%, 40%, 60%, 80%). These positions are based on
the Lower Limit Position of the shade. When learning new positions, the button currently being programmed (after Step 3.
TUG) will not send commands to the shade. After Step 5 all buttons resume full functionality.
Example 1: When learning a new Upper Limit Position, the UP button is semi-disable. Only by pressing the UP button 3 times
will the shade move to the up position (or manually roll the shade up by hand).
Example 2: When learning a new Lower Limit Position, the DOWN button is disabled. The shade can still be adjusted using
the UP button (or manually roll the shade by hand).
SETTING UPPER AND LOWER LIMITS / LEARNING A NEW POSITION
1. PRESS and RELEASE the (UP, DOWN, or PRESET) button that will be programmed
__(Shade will move to selected position)
2. PRESS and HOLD the same (UP, DOWN, or PRESET) button UNTIL the shade JOGS
3. TUG shade 6-10 inches (Shade will JOG in response)
4. ADJUST shade to desired position (Manually roll shade by hand if necessary)
5. PRESS and HOLD the same (UP, DOWN, or PRESET) button (Shade will JOG when learned)
DELETE / UNLEARN A REMOTE (or Channel)
(Shade at Upper Limit)
1. PRESS and RELEASE the CHANNEL button to select the channel currently paired to the shade
__
(Skip channel selection for Single-Channel Remotes)
2. Use a paperclip to PRESS the PROGRAM button on back of the remote
(The channel LEDs will scroll back and forth when in program mode)
3. PRESS and HOLD the UP button until Shade moves downward
4. TUG the shade 6-10 inches (Shade will JOG in response)
5. Use a paperclip to PRESS the PROGRAM button on back of the remote
(The channel LEDs will scroll back and forth when in program mode)
6. PRESS the DOWN button
(Shade will JOG, move to Upper Limit Position, then JOG again)
When unrolling the shade to expose battery cover, the shade will try to roll upward. Hold the FABRIC ROLL TUBE firmly in
place to resist the initial upward movement, then continue to unroll the FABRIC ROLL TUBE to expose battery cover.
BATTERY REPLACEMENT
1. PRESS and RELEASE the DOWN button (Shade will move to Lower Limit Position)
2. UNROLL the FABRIC ROLL TUBE to expose the battery cover (See IMPORTANT information above)
3. REMOVE battery cover and REPLACE with new NEW D-CELL Alkaline batteries
4. REPLACE battery cover (Shade will now respond to remote commands)
5. PRESS and RELEASE the UP button to roll fabric back onto the tube
FACTORY (MASTER) RESET (Will remove ALL paired remotes)
(Shade at Upper Limit Position)
1. Use a paperclip to PRESS the PROGRAM button on back of the remote
(The channel LEDs will scroll back and forth when in program mode)
2. PRESS and HOLD the DOWN button UNTIL the shade moves downward and JOGs
3. TUG the shade 6-10 inches (Shade will JOG in response)
IMPORTANT
IMPORTANT
www.qmotionshades.com
Pensacola FL, 32514
1 -877-849-6070
2
PN 9000217
Advertisement
