OutBack Power Alino TL Series Owner's Manual page 40

Troubleshooting
Table 8
Code Reason for Failure
F01 Both of the unit's fans have failed.
F02 Temperature is too high.
F03 Battery voltage is too high.
F04 Battery voltage is too low.
Output is short-circuited, or internal over-temperature
F05
is detected.
F06
Output AC voltage is too high.
Overloaded output (timeout has expired) or
F07
overloaded PV input.
F08 Internal bus voltage is too high.
F09 Internal bus soft start failed.
F51 Overloaded output.
F52 Internal bus voltage is too low.
F53
Incorrect voltage is present at AC output.
F55
Unbalanced AC output.
F57 Current sensor failed.
F58 Output AC voltage is too low.
F59 PV input voltage is too high.
Code Reason for Failure
U0 1 No USB device detected.
U02
Device is copy-protected.
U03
Device contains a document with the wrong format.
NOTE:
These codes may appear when a USB device is inserted and a problem is detected.
They appear for 3 seconds before the display returns to the main screen.
Circuit
Breaker
40
Error Codes (with unit failure and alarm)
Table 9
displayed here
Figure 31
Notes
This may require service.
The unit will recover after reaching the set
point in item 07. (See page 32.)
This can be corrected externally.
This can be corrected externally.
This may be able to be corrected externally.
This may require service.
The unit will recover after reaching the set
point in item 06. (See page 32.)
This may require service.
This may require service.
This can be corrected externally.
This may require service.
This may require service.
This may require service.
This may require service.
This may require service.
This can be corrected externally.
USB Fault Codes
Fault codes
(error or
warning)
Troubleshooting Features
AC LED Indicator
Fault LED Indicator
900-0248-01-00 Rev A