OutBack Power Alino TL Series Owner's Manual page 23

7 :
This display section shows the Setting screen mode option numbers. The Setting mode is
!
RUN TIME EST
SETTING
followed by the
codes. A Warning code is followed by
information on this section.
8 :
INPUT BATT AC PV
This display section shows AC input voltage and frequency, PV voltage, charging current and
M
kWh
VA
%
Hz
power, and battery voltage.
monitored. See page 24 for more information on this section.
9 :
OUTPUTBATTTEMP
This display section shows AC output voltage and frequency, load percentage, load in volt-amps
M
kWh
VA
%
C
Hz
and watts, and discharge current. See page 24 for more information on this section. Also, in the
Setting screen mode, this item shows the value being set. (See page 31.)
10 : This icon indicates that PV is connected. (See 12 .)
11 : This icon indicates that the utility grid is connected. (See 13 .)
12 :
This icon is a DC-DC conversion symbol indicating that the system is harvesting PV energy.
The MPPT indicator means the system is using maximum power point tracking. (See page 26.)
This power may be used for several functions. (See pages 27 through 30.)
13 :
This icon is an AC-DC conversion symbol indicating that the utility grid is charging the battery.
(See page 27.)
14 :
This icon is a DC-AC conversion symbol. In a battery-based system, it indicates the inverting
function is using battery power to run loads. (See 17 and page 29.) In a non-battery system,
it indicates the system is directly converting PV energy to run loads.
15 :
This icon indicates the estimated battery state of charge. When discharging the batteries,
the number of bars shows the remaining capacity. (The estimate is based on a combination
of battery voltage and load).
A = 0 to 24%
o
A , B = 25 to 49%
o
A , B , C = 50 to 74%
o
A , B , C , D = 75 to 100%
o
When charging (indicated by
that are on, the closer the batteries are to a full charge. When A , B , C , and D are all on, the
batteries are full.
16 :
This icon indicates that the audible alarm is disabled. See page 32.
17 :
This icon indicates the load level compared to the inverter's maximum load capacity (0 to 24%,
LOAD
25 to 49%, 50 to 74%, 75 to 100%)
18 :
This icon indicates the inverter has shut down due to overload. See page 40.
Hi
OVERLOAD
19 :
This icon indicates a USB drive has been connected.
20 :
This icon indicates Bluetooth service is established.
900-0248-01-00 Rev A
icon. (See 9 and page 31.) This item also shows any warning or error
SETTING
⚠
BATT AC
,
C
A
), some bars will be on and some will flash. The more bars
. An error code begins with F. See page 39 for more
PV
, or appear, depending on which source is being
D
B
Operation
23