Figure 5 Linkit Smart 7688 Web Ui Set Password - MEDIATEK LinkIt Smart 7688 Get Started Manual

You'll learn how to connect LinkIt Smart 7688 to the internet in later steps. But first, you need to configure the
board.
Step 3: Access the LinkIt Smart 7688 Web UI Configuration Tools
You now setup the LinkIt Smart 7688 Web UI, a tool for configuring the settings of you board.
1) In your web browser open http://mylinkit.local, as shown Figure 5.
2) Set a password using at least 6 alphanumeric characters and click SUBMIT. Enter the password again
and click Sign In.
If the board already has a password and you don't remember it, use a USB drive to upgrade the firmware or press
and hold the Wi-Fi button for at least 20 seconds and release to return the board to the factory defaults. Keep in
mind if you use either of these methods, it will restore to board's default settings and all user data will be removed
from the device. For more information on how to upgrade firmware using a USB drive or use the buttons please
refer to LinkIt Smart 7688 Developer's Guide.
Unauthorized reproduction or disclosure of this information in whole or in part is strictly prohibited.
MediaTek LinkIt™ Smart 7688 Get Started Guide

Figure 5 LinkIt Smart 7688 Web UI Set Password

© 2015 MediaTek Inc.
This document contains information that is proprietary to MediaTek Inc.
Page 5 of 15