Figure 10 Putty Security Warning; Figure 11 System Console Window - MEDIATEK LinkIt Smart 7688 Get Started Manual

2) A Security Alert window will pop up as shown below, this happens when you use PuTTY for the first
time, or after upgrading firmware, or uses a different board. Click Yes.
3) The PuTTY terminal window displays. Log in with username root and the password you set previously
in the Web UI, after log in you should see a screen similar to Figure 11.
In Mac or Linux:
Open Terminal and at the command prompt type ssh root@mylinkit.local. Press return and enter the
password you set previously in the Web UI.
If you see a warning error indicating host ID has changed, please check the Troubleshooting section in the
MediaTek LinkIt Smart 7688 Developer's Guide.
You now have access to system console using SSH.
Unauthorized reproduction or disclosure of this information in whole or in part is strictly prohibited.
MediaTek LinkIt™ Smart 7688 Get Started Guide

Figure 10 PuTTY Security Warning

Figure 11 System console window

© 2015 MediaTek Inc.
This document contains information that is proprietary to MediaTek Inc.
Page 9 of 15