Sony D-VM1 Operating Instructions (primary manual) Operating Instructions Manual page 56

Connecting to a Dolby Surround Pro Logic decoder amplifier (receiver) and 3
C
to 6 speakers
This connection will allow you to enjoy the surround effects of the Dolby Surround Pro Logic
decoder on your amplifier (receiver). If you have an AV amplifier (receiver) equipped with a
Dolby Digital, MPEG audio, or DTS decoder, refer to page 58.
You can enjoy the Dolby Surround effects only when playing Dolby Surround audio or
multichannel audio (Dolby Digital) discs.
Pro Logic uses a minimum of 3 speakers (front L and R, and rear (monaural)). The surround
effects are enhanced if 6 speakers (front L and R, center, rear L and R, and subwoofer) are used.
If your amplifier (receiver) has R and L audio input jacks only, use
(receiver) has a digital input jack, use
xRecommended surround sound effects using this connection with your
amplifier (receiver)
• Dolby Surround Pro Logic
(Set "SOUND MODE" to "NORMAL" in this case.)
z
For correct speaker setting location, please refer to the operating instructions of the amplifier (receiver).
56
C-2
.
. If your amplifier
C-1