Step 3: Connecting The Audio Cords - Sony D-VM1 Operating Instructions (primary manual) Operating Instructions Manual

Note
Do not connect your player to a VCR. You may not receive a clear image on the TV screen if you pass the player
signals via the VCR.

Step 3: Connecting the Audio Cords

Refer to the chart below to select the connection that best suits your system. The surround effects
you will enjoy depend on the connections and components you use.
Select a connection
Select one of the following connections,
Connection
(page 53)
A
(page 54)
B
(page 54)
B
(page 56)
C
(page 58)
D
* Manufactured under license from Dolby Laboratories. "Dolby," "Pro Logic," and the double-D symbol are
trademarks of Dolby Laboratories.
** Except for the USA and Canadian models
*** "DTS" is a registered trademark of Digital Theater Systems, Inc.
52
CD/DVD player
Connect directly.
through
A
Components to be connected
TV (stereo)
Stereo amplifier (receiver)
(having L and R audio input jacks only, or having a digital input jack)
• 2 speakers
(front L and R)
MD deck/DAT deck
AV amplifier (receiver) with a Dolby* Surround Pro Logic decoder
(having L and R audio input jacks only, or having a digital input jack)
• 3 speakers
(front L and R, and rear (monaural))
• 6 speakers
(front L and R, center, rear L and R, subwoofer)
AV amplifier (receiver) having a Dolby Digital, MPEG** audio, or
DTS*** decoder, and a digital input jack
• 6 speakers
(front L and R, center, rear L and R, subwoofer)
VCR
TV
.
D