Photo - Lexmark E330 Technical Instructions

Lexmark E232/330/332 Technical Instructions

Photo 12

Photo 13
Photo 14
Photo 15
Photo 16
Step 11
To clean the developer roller, take a lint-
free cloth, add a small amount of alcohol
and soak the cloth in distilled water. Place
the developer roller axle into a drill. Clean
the developer roller using the lint-free
cloth while the roller is rotating in the
drill. (See Photo 12)
Step 12
Slide the doctor bar down toward the
developer roller opening and remove the
bar.
(See Photo 13)
Step 13
Remove the toner from the doctor
bar using compressed air or a vacuum.
Clean the contact edge of the bar using a
cotton swab and Acetone.
(See Photo 14)
Step 14
Remove the cartridge warranty sticker
from the side of the cartridge.
(See Photo 15)
Step 15
Remove the toner hopper fill cap from
the end of the cartridge. (See Photo 16)
Carefully clean the hopper using dry
compressed air or a vacuum. Do not
damage the developer roller sealing
blade that sits under the developer roller.
Step 16
Install the doctor bar so the bar
sits over the doctor bar sealing
blade attached to the toner
hopper, (See Photo 17) and
under the positioning posts on
both side of the hopper.
(See Photo 18)
Photo 17
Photo 18
Notes
3