Page 1
Bulletin MSG30-8214-INST/UK Installation and Startup Manual Hydraulic Pumps Series VP1-095 /-110/ -130 Visit our homepage for additional support parker.com/pmde Effective: March 01, 2018 Supersedes: September 05, 2017...
Page 2
(left hand must be ordered if this is not possible, please contact separately (see shown) Parker Hannifin for further information. pg. 7) 5. A separate drain line must be installed between the control drain port T and the 2 x M12 reservoir (refer to fig.
Page 3
VP1 shaft Leif A./11-02-04 b) or c) above, is considered, contact Parker Hannifin. Fig. 4. VP1-095 / -110 / -130 shown with a bearing supported gear on an engine PTO adapter (example). Parker Hannifin Pump &...
Page 4
BPV-VP1 φ 6.5 unloading valve " (x2) (x3) 51.5 �40 BPV-VP1_unloading_valve.ai Fig. 5. BPV-VP1 unloading valve. Leif A./09-04-15 For more information also see MSG30-8226-INST/UK, Installation Information Unloading Valve BPV for VP1 Parker Hannifin Pump & Motor Division Europe Trollhättan, Sweden...
’L ower’ ’Upper’ plug purge purge plug Inlet (suction) line VP1_095_below_tank_ny2.ai Fig. 6. Purging the VP1-095 / -110 / -130 (right hand pumps shown) Leif A./07-03-29 Parker Hannifin Pump & Motor Division Europe Trollhättan, Sweden...
Page 6
- For additional information, please contact Parker Hannifin. Adjustments (refer to fig. 7 below) 1. System (high) pressure adjustment screw; factory set at 350 bar (1 turn approx.
Page 7
- Replace damaged parts. - Make sure you have corrected the source of the problem, not only the symptom. Parker can not be held responsible for damage to PTO, engine and gear- box caused by improper maintenance of the hydraulic system. Parker Hannifin Pump &...
The user must analyze all aspects of the application, follow applicable industry standards, and follow the information concerning the product in the current product catalog and in any other materials provided from Parker or its subsidiaries or authorized distributors.
Need help?
Do you have a question about the VP1-110 Series and is the answer not in the manual?
Questions and answers