Team Can 2 - Bosch IMSA Prototype Classes Scrutineering System Manual

4 | System Architecture
16 / 47

Team CAN 2

4.1.3
NOTE:

One termination resistor will be built into the scrutineering loom. The other
termination resistor must be present in the team wiring of the CAN
connection, external of the scrutineering loom.

CAN buses must be laid out in a linear fashion, with a termination resistor
(120 ohm) at each physical end of the bus.
Driver ID
4.1.4
The Driver ID will be an input on the same connector as the team CAN connections.
The Driver ID signal will be controlled by a different resistance value for each driver.
The resistor will go between the two pins for Driver ID with nothing else in the
circuit. The Driver ID and resistor value pairings are in the table below:
ID
1
2
3
4
5
IMSA Prototype Class Scrutineering Logger
Resistor Value (Ohm)
0
820
2.2K
4.7K
12K
Bosch Motorsport