Pitot Tube; Laser Ride Height; Temp Sensor - Bosch IMSA Prototype Classes Scrutineering System Manual

3 | Components
12 / 47
3.3.3

Pitot Tube

Functional Description: Temperature and pressure sensor
Use Case:
Dynamic Conditions:

Measure dynamic conditions of air flowing over the car.
o
Mounting Note:

Pitot sensor must be mounted in the IMSA homologated position.
o
No other pitot tubes are permitted on the car.
Part Number: F02U.V0U.264-01
3.3.4

Laser Ride Height

Functional Description: Dynamic ride height measurement
Use Case:
Ride Height:

Measure dynamic ride height of car in multiple locations.
o
Each manufacturer may select a sensor to be approved by IMSA.
o
Mounting Note:

Ride height sensors must be mounted in the IMSA homologated
o
position connected to the scrutineering system if run. No other ride
height sensors are permitted on the car.
Harness Pinout:

Connector
Pin
1
2
3
4
5
3.3.5

Temp Sensor

Functional Description: Temperature sensor
Use Case:
Plenum Temperature (NA engines):

Intercooler Upstream Temperature (Turbo engines):

Inlet Port Temperature:

Cockpit Temperature:

Callout: Driver's left bank will be Sensor #1
Part Number: F02U.V02.356-01
Temperature Range: -55 to 300 °C
Thread: M6 x 1
Installation Torque: 8 Nm
IMSA Prototype Class Scrutineering Logger
ASL606-05SC
Description
12V+ KL.30
GND
Signal
Bosch Motorsport