WEG MMW03-M22CH User Manual page 35

Adress Parametre
622 Neutral Current Alarm Delay Time
624 Cosφ Alarm High Limit
626 Cosφ Alarm Low Limit
628 Cosφ Alarm Hysteresis
630 Cosφ Alarm Delay Time
632 Power Factor Alarm High Limit
634 Power Factor Alarm Low Limit
636 Power Factor Alarm Hysteresis
638 Power Factor Alarm Delay Time
640 Frequency Alarm High Limit
642 Frequency Alarm Low Limit
644 Frequency Alarm Hysteresis
646 Frequency Alarm Delay Time
Device Model
648 Device Firmware Version
650 Device Model
Password/Pin activation
652 Setting protection
Reset Commands
1000 Reset Energy Values
1002 Reset Counter Values
1004 Reset Max. Values
1006 Reset Min. Values
1008 Reset Demand Values
1010 Reset Settings
1012 Reset Alarm Limits(MMW03-M22CH)
1014 Reset the Device to Factory Settings
Save The Changes
2000 Save Changes
Manual Output Relay Control
Enable Relay Control
4000
Relay 1 Control
4002
Relay 1 Control
4004
Enable/Disable to Assigning Predefined Value for Energy Meters
5000 Enable Counter Change
Type Read / Write
32 bit integer R / W
float R / W
float R / W
float R / W
32 bit integer R / W
float R / W
float R / W
float R / W
32 bit integer R / W
float R / W
float R / W
float R / W
32 bit integer R / W
float
32 bit integer
32 bit integer R / W
32 bit integer
32 bit integer
32 bit integer
32 bit integer
32 bit integer
32 bit integer
32 bit integer
32 bit integer
32 bit integer
32 bit integer
32 bit integer
32 bit integer
32 bit integer
Tabela 4.1: Readable and Writable Data
Write Condition
Enter the password in the "Settings
Protection" field if password protection is
RO
RO
Address for the device password. It displays
the enabled/disabled condition of the
password protection when reading using.
WO
WO
Enter the password in the "Settings
WO
Protection" field if password protection is
WO
enabled. Enter "1" into the respective address
WO
to reset the values. Enter "0" before saving to
WO
restore the values.
WO
WO
Enter the password in the "Settings
Protection" field if password protection is
WO
enabled. Enter "1" to save the changes and
Enter the password in the "Settings
Protection" field if password protection is
WO enabled. Enter "1111" here to enable the relay
control. Enter "0" here to disable the relay
Enter the password in the "Settings
Protection" field if password protection is
WO enabled. Then, enter "1111" for the "Enable
Relay Control" address. Enter "1" to activate,
"0" to de-activate the relay.
Enter the password in the "Settings
Protection" field if password protection is
WO enabled. Then, enter "1111" for the "Enable
Relay Control" address. Enter "1" to activate,
"0" to de-activate the relay.
Enter the password in the "Settings
Protection" field if password protection
WO is enabled. Enter "2222" here to enable
assigning the relay control. Enter "0" here to
disable the meter assignment.
Energy Analyzer - MMW03-M22CH | 35
www.weg.net
enabled.
restart.
control.