Opening The Pressure-Resistant Housing - SAMCOM ExCam XF P1367 User Manual

6.2

Opening the pressure-resistant housing

„WARNING – MUST NOT BE OPENED IN HAZARD AREAS"
Note: Depending on classification of hazard areas, a work approval
has to be obtained.
Even after switching on the power supply, it is absolutely imperative
to avoid potentially explosive atmosphere when opening the camera
housing. Opening the housing requires disassembly and working in a
safe (i.e. non-explosive!) area.
Attention!
Pay attention not to damage the thread surface of the flame-proof gap.
Attention!
Pay attention not to damage the housing seals. Keep them clean!
If the ExCam XF P1367 is equipped with a weather protection roof (optional accessory),
remove the roof before you start working! To do so, untighten the 4x8mm lens screws
M4*0.7 at the front and rear sides of the bracket holders (Fig. 6-1).
Fig. 6-1 Removing the weather protection roof (1/2) (this illustration is an example)
Doc.-ID: 190314-PT08BA-ES-ExCam XF-P1367_EN_rev.00.docx, Page 20 of 32