Philips 170X7FB/00 Service Manual page 33

8. Click Next , bring up Fig. 43.
- In this step, please confirm the Descriptor Data Type is Monitor
Range Limits, and all the items are same as below.
- Click Finish to exit the Step window.
- Serial number can be filled up at this moment (for example, TY
123456).
Fig. 43
Step 5: Write DDC data
1. Configuration should be as Fig. 40. And press OK.
2. Access Factory Mode
1). Turn off monitor.
2). [Push "AUTO" & "OK" buttons at the same time and hold them]
+[Press "power" button untill comes out "Windows screen" ]
=> then release all buttons
3).Press "OK" button, wait until the OSD menu with Characters
"HUDSON 170C7 V010 2006/06/29" (below OSD menu) come on
the Screen of the monitor. as shown in Fig24.
Factory Mode indicator
Fig. 45
3) Push Menu to exit OSD menu. " "
3. Click (Write EDID) icon from the tool bar to write DDC data.
Then wait for 20-30 seconds ,DDC data will be finished Writing.
Step 6: Save DDC data
Sometimes, you may need to save DDC data as a text file for using in
other IC chip. To save DDC data, follow the steps below:
1. Click (Save) icon (or click "file"-> "save as") from the tool bar and
give a file name as shown in Fig. 46.
The file type is EDID46 file (*.ddc) which can be open in WordPad. By
using WordPad, the texts of DDC data & table (128 bytes, hex code)
can be modified. If DDC TEXTS & HEX Table ar completely correct, it
can be saved as *.ddc flie to re-load it into DDC IC for DDC Data
application.
DDC Instructions
2.
Step 7: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 47.
Fig. 44
Step 8: Turn off the monitor, exit the factory mode.
BOM Code
Panel Supplier
AUO
CPT
LPL(LG)
QDI
CMO
B Z 1 A 0 6 2 5 0 0 0 0 0 1
Fig.46
Click Save.
Fig. 47
Serial Number Definition
CODE
1
2
3
4
5
SERIAL NO
YEAR/WEEK
SERVICE VERSION CHANGE CODE
BOM CODE(BILL OF MATERIAL)CODE
SITE CODE(PRODUCTION CENTER)
BZ CODE(AR-CZECH REPUBLIC
VN-HUNGARY(SZR),BZ-SUZHOU
DS-DONGGUAN)
33
190X7&170X7 LCD
Go to cover page