Table of Contents
Advertisement
User Manual
IKORE B Transmitter
Technical description
IKORE startup
RX
I
II
6 |
©
Danfoss | January 2019
1. Place the EEPROM and fully charged alkaline batteries or rechargeable battery if applicable.
2. Push and pull out the STOP button.
The status LED will blink in blue until it reaches the stand-by mode and then it will turn into a fixed
blue.
RX
I
II
I
II
[1]
3. Press the start button.
The LED will blink green until the transmitter is linked with the receiver.
RX
RX
I
II
I
II
I /I+II /II
* Data sheet
When the receiver confirms the link, the status LED will turn to a fixed green and the system is now fully
operational.
When the system controls two hoists, there will be a push button for the selection of individual or joint
control. I and II LEDs will show their selection.
I
II
[1]
RX
I
II
II
I
I /I+II /II
* Data sheet
[1]
RX
I
II
I /I+II /II
* Data sheet
BC292582855621en-000101
Advertisement
Table of Contents
