SGM LEKTRA PTU51 Manual

Technical Data
Housing material:
Mechanical installation:
Sensor protection degree:
Electrical connection:
Working temperature:
Pressure:
Power supply:
Power consumption:
Analog output:
Digital communication:
Measure range:
[In case of non perfectly reflecting surfaces, the maximu distance
value will be reduced]
Blind distance:
Temperature compensation:
Accuracy: ±0,2% (of the measured distance)
Resolution:
Calibration: VLW601 prog. module with 4
Warm-up:
LCD Display:
fig.1
fig.2
PTU51
Ultrasonic level transmitter
PP or PVDF
1"GAS M
IP68 or IP69K male connector
with 5/10/15/20m linking cable
-25° ÷ +75°C
da 0,5 a 1,5 bar (absolute)
4÷20mA max 750ohm
MODBUS RTU
0.3÷6m
digital from -30 to 80°C
not better than ±3mm
buttons
or by MODBUS RTU
30 minutes typical
VLW601 wall mounting module
applied solution for the application
IP68
24Vdc
1,5W
0,3m
1mm
PTU51
Important!!! close to the sensor there is a "blind zone" of
0.3m where the instrument can't measure (see fig.3). To
reach a good and safe measurement, avoiding spurious
echoes (not reflected by the surface), take care of the
positioning of the PTU51 sensor and check that no obstacles
are interferring with the ultrasonic waves emission lobe (see
fig.2).
Install
perpendicularly
to the surface
825B124A
Mechanical Installation
Avoid to install in
Do not use
with foaming case of product
products level
<0.3m from the
sensor
fig.3
distance