Acs380 Minimum Required Parameter Settings Profibus Ds - ABB ACS355 Series Quick Start Up Manual

17

ACS380 Minimum required parameter settings PROFIBUS DS

The minimum required parameter settings based on factory default settings.
Parameter Description
50.01 FBA A Enable
51.02 NODE
ADDRESS
51.05 PROFILE
52.02 FBA data in2
53.02 FBA data out2
51.27 FBA par refresh
20.01 Ext 1
commands
22.11 Ext1 speed ref1
31.11 Fault reset
selection
(46.01) Speed scaling
Setting Comment
Enable Activates fieldbus module
[PB NODE] PROFIBUS DP node address of the drive
1 Communication profile ABB drives
Act1 16bit (5) Actual speed as Data Word 2 from the drive
Ref1 16bit (2) Speed reference as Data Word 2 to the drive
Configure Updates fieldbus settings (groups 50 to 57)
Fieldbus A Fieldbus interface as source for start and stop
FB A ref1 Fieldbus interface as source for speed reference
P.06.01 bit 7 Fieldbus interface as source for fault reset
[Scale max] Max speed/frequency scaling value (used in
function block/visualization input
SPEED_REF_MAX). Must be less or equal to
drive parameter max speed/frequency.