Sony JumboTron Operating Instructions Manual page 21

2 Selecting the target of luminance adjustment and setting the unit to the proper
brightness level for carrying out the adjustment
5
Select the manual adjustment mode with the ∫ or ı button, or the 0 to
A numberic buttons.
The mode changes in the following order each time you press the ∫
button. (Pressing ı button changes the mode in the reverse order.)
You can also select the mode by pressing the button in brackets. When
you select the mode marked with an asterisk (*), use the buttons in
brackets.
JTU-35
PWM-White [0] PWM-Blue [1]
PWM-Green (G) [7]
* G1-VOLTAGE (G) [8], * G1-VOLTAGE (R) [9], * G1-VOLTAGE (B) [A]
JTU-17
G1V-White [0] G1V-Blue [1]
G1V-Green (G) [7]
* REF-VOLTAGE (B) [8], * REF-VOLTAGE (R) [9], * REF-VOLTAGE (G) [A]
LDU-15, LDU-30
If-White [0] If-Blue [1] If-Red [2]
If-Green (G) [7]
* If-Range (B) [8], * If-Range (R) [9], * If-Range (G) [A]
You can adjust the luminance of the whole unit or a specified cell or pixel.
If necessary, you can set the luminance or brightness of the whole unit to
the level at which you can easily make the adjustments. If not necessary to
set, skip steps 8 and 9 on page 22.
6
Press the SETUP button.
A D J U S T S e t U p
A D J : P W M - W H I T E
T a r g e t : U N I T
L u m i n a n c e : 0 7 F
B r i g h t n e s s : 0 7
U N I T T Y P E : J T U - 3 5
PWM-Red [2] PWM-Green [3]
PWM-Red (R) [6] PWM-Blue (B) [5]
G1V-Red [2] G1V-Green [3]
G1V-Red (R) [6] G1V-Blue (B) [5]
If-Green [3] If-Range [4]
If-Red (R) [6]
Target of adjustment
Luminance
Brightness
G1-VOLTAGE [4]
REF-VOLTAGE [4]
If-Blue (B) [5]
(Continued)
21