Advertisement
Quick Links
Advertisement
Related Manuals for Kratki NADIA Series
Summary of Contents for Kratki NADIA Series
- Page 1 The series of NADIA fireplace inserts General manual and warranty card...
- Page 2 The series of NADIA fireplace inserts NADIA/8, NADIA/10, NADIA10/G, NADIA10/PW/W, NADIA/12, NADIA/12/G, NADIA/13, NADIA/13/G, NADIA/14, NADIA/14/G, NADIA14/L/BS/G, NADIA 14/P/BS/G NADIA/8 NADIA/10 NADIA/12 NADIA/13 NADIA/14 NADIA/10/G NADIA/12/G NADIA/13/G NADIA/14/G...
-
Page 3: General Information
NADIA/14/PW/W Thank you for the confidence shown to us by purchasing the fireplace insert manufactured by kratki.pl. Before fitting and using the insert, please read these instructions. General information NOTE! To avoid the risk of fire, the device must be installed in accordance with the current standards and the technical regulations referred to in the manual. - Page 4 Do not put wood to the full of the chamber, the optimal amount of fuel is one that fills the com- bustion chamber in about 1/3 of its volume. Before adding wood, wait until the flames are lower, do not add wood while burning as well as too much grate. Fuel: due to the design of our equipment, the recommended fuel can be: oak, hornbeam, ash, beech wood, etc.
- Page 5 Technical drawings / dimensions of the NADIA series...
- Page 11 Dimensions of inserts / volumes of combustion chambers of the NADIA series...
- Page 14 13229:2002 standard “Fireplace inserts with open fires using solid fuel. Requirements and Tests. ” 2. Intended use The fireplace inserts manufactured by Kratki.pl use solid fuels with manual loading of fuel and lockable doors. They are designed for trimming or locating into a niche. They are designed to burn hardwood i.e.
- Page 15 of proper exhaust grilles under it to emit exhaust heat from the chamber above the fireplace. Grilles (decompression ones) are mounted on both sides of the housing on opposite sides, e.g. alter- nately higher and lower than the decompression shelf. They enable intensive air flow - circulation, which cools the surface of the ceiling.
- Page 16 Technical specifications of the Nadia inserts NADIA/14 NADIA/10 NADIA/10 NADIA/12 NADIA/13 NADIA/14/G NADIA/8 NADIA/10/G NADIA/12/G NADIA/13/G NADIA 14/L/BS/G NADIA 14/P/BS/G nominal power (kW) power range 6-14,4 5-13,5 8-16 7-16 6,5-17 <kW< water circula- tion power kW diameter of flue gas exhaust (mm) insert perfor- ~ 80...
- Page 17 Changing the NADIA insert door opening (left-side opening) Changing the NADIA insert door opening (right-side opening possible after changing the door side)
- Page 18 Solutions used in the Nadia series of fireplace inserts enable changing the standard left-hand door opening to the right-hand one. First, protect the safety element of the insert door against accidental falling down from hinges (1). Following opening the door to an angle of 90°, lift it to release the lower hinge (2) (3).
- Page 20 The way the Nadia Guillotine door is opened a)Unscrewing the screws securing the weights b)Standard opening and opening to the side c) Opening to the side is possible after the lock and the lower and upper locks are released...
- Page 22 d) Opening the door up / down.
- Page 23 4. Mounting and installation of a fireplace insert Installing a fireplace insert should be performed by a person with licenses for performing this type of assembly work. It is a condition of safe use of the fireplace insert. The installer should confirm the correct execution of the assembly by signing the warranty card and stamping it.
- Page 24 Wall Insulation Fireplace insert Minimum distances of the insert: A - min. 150 cm B - min. 12-15 cm - when using the air distribution system to other rooms, in order to obtain free circulation of air, ensure that it could return to the room where the fireplace is installed after it is cooled down. Failing to stick to this rule may disturb the cycle of the insert and prevent distribution of the heated air.
- Page 25 - insulated flexible ducts characterized by the minimal resistance up to 250 ° C (fully non-flammable); - supply device - a turbine. All of the above elements can be found in our offer. The DGP system installation should be entrusted to a specialized company that will design a proper system of connections and the distribution of individual elements.
-
Page 26: Operation Principle
Note: It is forbidden to use other materials than those provided in the instructions. Do not use flammable chemical products to ignite, such as oil, gasoline, solvents and others. Operation principle. Diagram of air circulation in the NADIA inserts Description of air circulation in the NADIA inserts Aeration of the combustion chamber is realized only from the outside. - Page 27 Combustion, loading After lighting the fire and partial burning of the first batch used to ignite and produce a layer of ignition grate, add wood to the combustion chamber of the insert, arranging fuel to evenly fill the chamber according to the expected time of firing, as specified by the user, basing on individual experiences, but not more than 1 / 3 of the total capacity of the combustion chamber.
- Page 28 Anomalies in the operation of the fireplace insert During operation of the fireplace, some anomalies can happen, suggesting irregularities in the op- eration. This may be caused by improper installation of the fireplace without sticking to the existing legislation or the provisions of this manual or due to external causes, e.g. the environment. Below you can find the most common causes of the insert malfunctions along with their solutions.
- Page 29 Act of 27 July 2002 on special condi- tions of consumer sales. In order to constantly improve the quality of its products, kratki.pl reserves the right to modify the devices without prior notice.
-
Page 30: Support Services
SELLER Stamp and signature of the seller; Name: Address: Telephone/fax: Date of sales: PURCHASER: The free-standing stove should be installed in accordance Date and legible signature of the purchaser; with the national regulations and rules, with the provisions of the manual, by an installer having relevant licenses. I declare that, after reading the instruction manual and the terms of the warranty, in cases of a failure to comply with the provisions contained therein, the manufacturer is not liable... - Page 31 SMOKE DUCT MAINTENANCE BOOK Inspection during the insert installation Date, signature and seal of the chimney sweeper Date, signature and seal of the chimney sweeper Date, signature and seal of the chimney sweeper Date, signature and seal of the chimney sweeper Date, signature and seal of the chimney sweeper Date, signature and seal of the chimney sweeper Date, signature and seal of the chimney sweeper...
- Page 32 Kratki.pl Marek Bal ul. Gombrowicza 4, Wsola, 26-660 Jedlińsk, Poland tel. 00 48 48 389 99 00, 00 48 48 384 44 88, fax 00 48 48 384 44 88 wew. 106 www.kratki.eu...