Table of Contents
Advertisement
4.
Installation Location
(1) Install the indoor unit with a proper clearance
around it for operation, maintenance working space
and safety, as shown in the illustration at right.
Unit Type
006 to 012
015 to 030
(2) Consider the air distribution from the indoor unit to the space of the room, and select a suitable location
so that uniform air temperature in the room can be obtained.
(3) Install the unit where there are no obstacles such as electric lights or a partition, which can impede the
suction air and discharged air.
In the case of using a wireless controller, avoid installing the indoor unit to within approximately
3.3ft (1m) from electronic type lighting so that the signal remains unaffected when transmitted to the
receiver.
(4) Check to ensure that the ceiling is able to withstand the weight of the indoor unit. If there is insufficient
structural integrity, noise in the form of vibration generated by the unit is magnified.
(5) Verify that the supporting walls are vertical and flat.
(6) Install the indoor unit as high off the floor as possible.
If not, airflow distribution will be affected and these effects will cause discomfort to some people.
Horizontal Airflow
(7) Do not install the unit near a door or ceiling where the indoor unit come into contact with humid outside
air. Otherwise, condensation may occur.
(8) Do not install the indoor unit where airflow from the air outlet blows directly onto temperature sensing
devices such as an alarm device or a control device. This can result in false readings and an alarm
failure.
P5417052
Unit: inch (mm)
a
b
5-7/8 (150)
3-15/16 (100)
3-15/16 (100)
7-7/8 (200)
As High as Possible
(Min. 94-1/2 inches (2400mm))
Vertical Airflow
Min.
3-15/16
(100)
Floor
* The above figure shows 006 and 008 type.
Unit: inch (mm)
Min.
b
9
Hide quick links:
Advertisement
Table of Contents
