Advertisement
JC MACHINERY & TOOLS INC.
iv.
Controller Panel
33
37
40
● ON/OFF switch（38）is used for open the main power of the welder.
● Open ON/OFF switch (38), LCD display is shown as figure 1, the hot air blower is under natural
wind without heating.
● Press the button (37) and (36), the screen shows as Figure 2 and the hot air blower
starts to heat until to the setting temperature.
● If press the bottoms (37) and (36) at the same time, LCD display shows as figure 1, the hot air
blower is under natural wind without heating.
● When the welding nozzle is at the right position, press the moving switch (39) and the welder
starts to move and weld. It will stop move if you press the moving switch again.
● When the welder starts to move, the LCD display shows as figure 3.
●
The knob (40) is used to adjust the air flow of the air gun, increase the air flow by rotating
clockwise, and reduce the air flow by rotating counter-clockwise.
___________________________________________________________________
www.jc-tool.com
36
info@jc-tool.com
Quality We Trust
32
35
34
39
38
Advertisement
