Advertisement

TYRO129
QUICK START GUIDE (DIY)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TYRO129 and is the answer not in the manual?

Questions and answers

Summary of Contents for Eachine TYRO129

  • Page 1 TYRO129 QUICK START GUIDE (DIY)
  • Page 2 TYRO129 QUICK START GUIDE Package Included: 1 x frame kit 2 x 2507-1800KV brushless motor CW 2 x 2507-1800KV brushless motor CCW 1 x 4In1 40A BLHeli_S ESC 1 x F4 Flight Controller 1 x Caddx.us Turbo f2 Camera 1 x 5.8G 40CH 25/100/200/600mw switchable VTX...
  • Page 3: Table Of Contents

    TYRO129 QUICK START GUIDE Contents 1.0 Frame kit----------------------------------------04 Motor----- ----------------------------------------04 3.0 Esc------------------------------------------------05 4.0 Flight controller---------------------------------06 5.0 Camera-------------------------------------------07 6.0 Switchable VTX------------------------------------07 7.0 Antenna------------------------------------------08 8.0 Eachine BN-220 GPS Module----------------08 9.0 Screws--------------------------------------------08 10.0 Assembly drawing-----------------------------09 11.0 Adjusting parameter----------------------------10-11...
  • Page 4: Frame Kit

    TYRO129 QUICK START GUIDE 1.0 Frame kit Wheel base: 280mm Frame arm thickness: 5mm Bottom plate thickness: 2mm Side plate thickness: 1.5mm Frame kit material: 3K carbon fiber 2.0 Motor KV: 1800KV Lipo cell: 3-6S Weight: 39g Whole shaft length: 35mm...
  • Page 5: Esc

    TYRO129 QUICK START GUIDE 3.0 ESC Continuous current: 40A Peak current: 45A (10S) BEC output: no Input voltage: 2-6S Main control chip: 48mhz EFM8BB2 Firmware upgrade: Supports Dshot150-600/Multishot/Oneshot/PWM Size: 37.5x37.5mm Mounting Hole: 30.5x30.5mm Features: High-performance EFM8BB21F16G microprocessor with operating frequency up to 48MHz;...
  • Page 6: Flight Controller

    TYRO129 QUICK START GUIDE 4.0 Flight controller Flight Control Name: EACHINE F4 Flight Controller Size: 37 × 37mm Mounting hole: 30.5 × 30.5mm Firmware version: MATEKF405 5V: 5V regulated power supply output interface, maximum current 2A (non-flying control, need to use Eachine BLHeli_S 40A 4in1 ESC) 4.5V: Receiver power interface (voltage only when...
  • Page 7: Camera

    TYRO129 QUICK START GUIDE 5.0 Camera Case size: 19x19x16mm Weight: 5.5g Signal system: NTSC / PAL (Switchable) Resolution ratio(horizontal center): 1200TVL Video output Signal: cvbs Image: 16:9 Synchronization method: inter-sync Camera lens: standard 2.1mm Lens operating voltage: DC 4.5-40V S/N Ratio: >52dB (AGC OFF) Audio: YES 6.0 Switchable VTX...
  • Page 8: Eachine Bn-220 Gps Module

    7.0 Pagoda Antenna Description: Brand name: Eachine Item name: antenna Quantity: 1 PC Conncetor: RP-SMA Male 8.0 Eachine BN-220 GPS Module Brand Name: Eachine Model: BN-220 Item Name: BN-220 GPS+GLONASS Dual GPS module - Built-in FLASH, TTL Data Protocol: NMEA-0183...
  • Page 9: Assembly Drawing

    TYRO129 QUICK START GUIDE 10.Assembly drawing...
  • Page 10: Adjusting Parameter

    TYRO129 QUICK START GUIDE 11.Adjusting parameter 1.Click connect connection 2: Click the RX interface under UART2 under the ports option, as shown in the figure. 3: Click CONFIGURATIN to change to dshot600. 4: Click CONFIGURATIN; change to SBUs 5: Click modes, add arm and angle, drag the slider between 1300...
  • Page 11 TYRO129 QUICK START GUIDE 11.Adjusting parameter 6: Push the slider to test the positive and negative rotation of the motor, such as error, 7: Click font manager, select betaflight, click upload font 8: Click setup, calibrate accelerometer -11-...

Table of Contents

Save PDF