Do you have a question about the Wizard X220s and is the answer not in the manual?
Questions and answers
Justus Beck
April 12, 2025
Hallo... Ich habe mir die Eachine Wizard x220s gekauft. Nach einem kleinen Crash (die Drohne ist aus 5 Fuß runtergefallen) hat die Drohne wenn man sie an den Strom angeschlossen hat auf der Rückseite bei den Leds rot geblinkt. Sie blinken durchgängig. Auch wird ein piep Ton abgespielt der regelmäßig ist. Die Flysky Fs-i6x ist korrekt verbunden. Ich kann die Drohne **** armen. Jedoch bekomme ich ein Bild in meine Fpv Brille. Was kann ich dagegen tun? MfG Justus
1 comments:
Mr. Anderson
May 14, 2025
The red blinking LED and beeping sound on the Eachine X220s after a crash typically indicate a failsafe or lost signal condition. To resolve FPV issues, increase the VTX power output (e.g., from 25mW to 100mW), ensure clean solder connections, and connect the camera ground to the VTX ground. Also, make sure the camera, flight controller, and FPV headset are all set to the same video format (PAL or NTSC).
Page 8
6. 0 Charging 7. 0 Additional instructions 1) Default s.bus for flight control receiver agreement 2) i-BUS/S.BUS mode switching: Switch output mode in normal communication between transmitter and receiver,Each time the long press of the key to keep the 2s can switch between i-bus/s.b-us output mode. *The indicator light first dies in a second and then flashes twice, indicating the successful switch to i-bus output mode.
Need help?
Do you have a question about the Wizard X220s and is the answer not in the manual?
Questions and answers
Hallo... Ich habe mir die Eachine Wizard x220s gekauft. Nach einem kleinen Crash (die Drohne ist aus 5 Fuß runtergefallen) hat die Drohne wenn man sie an den Strom angeschlossen hat auf der Rückseite bei den Leds rot geblinkt. Sie blinken durchgängig. Auch wird ein piep Ton abgespielt der regelmäßig ist. Die Flysky Fs-i6x ist korrekt verbunden. Ich kann die Drohne **** armen. Jedoch bekomme ich ein Bild in meine Fpv Brille. Was kann ich dagegen tun? MfG Justus
The red blinking LED and beeping sound on the Eachine X220s after a crash typically indicate a failsafe or lost signal condition. To resolve FPV issues, increase the VTX power output (e.g., from 25mW to 100mW), ensure clean solder connections, and connect the camera ground to the VTX ground. Also, make sure the camera, flight controller, and FPV headset are all set to the same video format (PAL or NTSC).
This answer is automatically generated