Table of Contents
Advertisement
8
TECHNICAL PROBLEMS
8.1
List of error messages displayed by the machine
The machine can display an error code during or after sharpening, if the operation
was unsuccessful. In this case, refer to the table below:
No.
Correspondence
0,1,3
System error
,4,14
2
Motor error
Critical motor
5
temperature
No motor stop
6
detection
Not enough drive
7
links
Supply voltage
8
too low
Supply voltage
9
too high
The file remains
10
stuck in the gouge
The left and right-
hand files are not
11
entering the
gouge
The right-hand file
12
is not entering the
gouge
The left-hand file
13
is not entering the
gouge
File stroke = 0 on
15
both sides
Pass on the information to UMV
Reset the software with a USB drive
Restart sharpening
If the problem persists, pass on the information to UMV
Do not use the machine in an excessively hot environment
(>50°C)
Check the circuit ventilation
Insert the missing guide(s) into the sharpener
Restart sharpening
Enter a number of drive links >= 2 (tooth every two links)
Do not use a power supply other than the one provided
The operating voltage range is 10V to 30VDC
Do not use a power supply other than that provided
The operating voltage range is 10V to 30VDC
Use a smaller-sized file to sharpen the chain
Reduce the cutting angle to help the file enter and exit the
tooth
Use a smaller-sized file to sharpen the chain
Adjust the chain pusher stop
Reduce the cutting angle to help the file enter and exit the
tooth
Set the left and right-hand files to the same cutting angles
Restart the chain by hand
Set the left and right-hand files to the same cutting angles
Restart the chain by hand
Insert a number of file stroke different from 0 on one of the
side (left or right)
53/64
Action(s) to take
Advertisement
Table of Contents
