Table of Contents
Advertisement
5.2
Assembly instructions
Secure the sharpener, as it could tip over and injure the user. To do so,
follow the instructions below:
No.
Place your V|OAK unit upright on a horizontal work surface.
(A)
Secure the sharpener via a seal clamp, or by screwing the device onto a table
(B)
via the holes provided for this purpose.
Fit the side safety guards.
(C)
Select and install the correct wall plug according to your geographic area (power
(D)
supply includes international plugs).
Connect the power supply to the male port leading out of the sharpener.
(E)
Assemble the file guides before fitting them in the sharpener.
(F)
The diameter of the round file is chosen according to the chain pitch used. See
the decision-making table in the "Operating parameters" chapter.
5.2.1
(B) - Stabilising the sharpener
Secure the sharpener using a seal clamp or screws (max. diameter 8 mm)
Description
19/64
Advertisement
Table of Contents
