Table of Contents
Advertisement
u Mounting Angle Braces
x
1
Insert two drop in nuts into
inner stand leg t-slots.
5
Slide up and align angle
brace with drop in nuts in
frame.
9
Check with bubble level to
ensure conveyor is level.
>
Repeat for opposite side.
Injury is possible if the stands are not lagged to the floor, cross ties are not used, or angle braces are not present. Never place a conveyor in operation until all proper
mounts are installed and secured.
Warning: Moving conveyors with casters can create dynamic forces that could tip the conveyor. Use caution when moving a conveyor with casters.
2
2
x
2
Insert drop in nuts into
conveyor frame's t-slot.
2
x
6
Insert socket head cap screws
through angle brace and into
nuts in conveyor frame.
3
Align angle brace over drop
in nuts in stand.
2
x
7
Tighten socket head cap
screws on frame.
AS65 Conveyors | Installation & Maintenance Instructions
2
x
4
Insert socket head cap screws
through angle brace and into
drop in nuts on stand (do not fully
tighten).
2
x
8
Tighten socket head cap
screws on stand.
7
Advertisement
Table of Contents
