Table of Contents
Advertisement
Stand Installation
Mounting Aluminum Stands to Conveyor
u Mounting Aluminum Exact Width Stands
Stands should be placed as close to ends of conveyor as possible. Stands may be placed a maximum of 10' apart for conveyors 6" wide or less with a load less than 20
lbs,; conveyors 8"-12" wide with a load less than 25 lbs.; conveyors 18"-24" wide. For all other conveyors, stands should be placed a maximum of 6' apart.
1
Remove the nuts holding the
stand attachment brackets to
the top of the stand and remove the
brackets.
5
Replace nuts and tighten.
2
Insert drop in nuts into t-slot
on conveyor frame.
3
Attach stand attachment
brackets to conveyor using a
5mm allen wrench.
For Conveyors 6" wide or less:
flange should point outboard;
spacer must be installed between
stand attachment bracket and
conveyor frame.
For conveyors more than 6" wide:
flange should point inboard; no
spacer is necessary
AS65 Conveyors | Installation & Maintenance Instructions
4
Place stand attachment
brackets atop stands.
5
Advertisement
Table of Contents
