Table of Contents
Advertisement
READ THIS PAGE FIRST
BEFORE STARTING INSTALLATION
j
You must read and understand the contents of this manual
before installing or operating your water refiner. Personal
injury or property damage could result if you fail to follow
instructions in this manual.
j
This system and its installation must comply with state and
local regulations. Check with your local public works
department for plumbing and sanitation codes. Local codes
should be followed In the event the codes conflict with any
content in this manual.
j
For installations in Massachusetts, Massachusetts Plumbing
Code 248 CMR shall be adhered to. Consult your licensed
plumber for installation of this system.
j
This water refiner must be operated on pressures
between 30 psi to 125 psi. If the water pressure is higher than
125 PSI, use a pressure reducing valve in the water supply
line to the refiner.
j
This unit must be operated at temperatures between 40°F and
110°F (4°C - 43°C).
j
Do not use this water refiner on hot water supplies.
j
Do not install this unit where it may be exposed to wet
weather, direct sunlight, or temperatures outside of the range
specified above.
INSTALL NOTES &
SAFETY MESSAGES
Watch for the following
messages in this manual:
j
Apply provided NSF certified lubricant to all o-rings during
installation. Do not use pinched or damaged o-rings during
installation.
j
Refiners are exposed to high levels of iron, manganese,
sulfur, and sediments. Damage to pistons, seals, and or
spacers within the control valve are not covered in this
warranty due to the harsh environment.
j
It is recommended to annually inspect and service the control
valve. Frequent cleaning and or replacement of piston, seals,
and or spacers may be necessary depending on how harsh the
conditions are.
j
Do not use water that is microbiologically unsafe without
adequate disinfection before or after this system.
j
This publication is based on information available when
approved for printing. Continuing design refinement could
cause changes that may not be included in this publication.
See page 7 for unpack and inspect system
Nuvia®™ reserves the right to change the specifications
referred to in this literature at any time, without prior notice.
NOTE
Do not remove or destroy
the serial number. It must
be referenced on request
for warranty repair or
replacement
CAUTION!
Disassembly while
under pressure can
result in flooding.
WARNING!
ELECTRICAL SHOCK
HAZARD! UNPLUG THE UNIT
BEFORE REMOVING THE
COVER OR ACCESSING ANY
INTERNAL CONTROL PARTS
NOTE:
used to emphasize
installation, operation or
maintenance information
which is important but does
not present a hazard.
CAUTION:
used when
failure to follow directions
could result in damage to
equipment or property.
WARNING:
used to
indicate a hazard which
could cause injury or death if
ignored.
3
Advertisement
Table of Contents
