Maintenance Instructions And Schedule - NUVIA Signature NW-SIG-948-1.0 Owner's Manual

Dynamic regeneration

Table of Contents

MAINTENANCE INSTRUCTIONS CONTINUED FROM PAGE 19

MAINTENANCE INSTRUCTIONS AND SCHEDULE

CHECKING THE SODIUM LEVEL

Check the sodium level monthly. Remove the lid from the brine tank, make sure SODIUM level is always above the brine level.

ADD SODIUM TO THE BRINE TANK/CABINET

Put 88 lbs of crystal water refiner sodium in the brine tank. The unit will automatically fill the water to the correct level when it

regenerates. Use only clean sodium labeled for water conditioner use, such as crystal, pellet, nugget, button or solar. The use of rock

SODIUM is discouraged because it contains insoluble silt and sand which build up in the brine tank and can cause problems with the

system's operation. Add the sodium directly to the tank, filling no higher than the top of the brine well.

NOTE: THE WATER LEVEL SHOULD BE BELOW THE SODIUM LEVEL ALL THE TIME

Sodium

Water

IMPORTANT WARRANTY AND MAINTENANCE INFORMATION

PLEASE HAVE THE INFORMATION BELOW FILLED OUT AND AVAILABLE WHEN CALLING IN FOR PARTS OR

WARRANTY:

Model number:

Serial number:

Valve Serial number:

Date installed:

ADDITIONAL NOTES:

_______________________________________________________________________________________________________________

REPLACING MEDIA BED

Frequency of replacing bed is determined

by water quality and usage. If you start

getting chlorine smell or grey / black

coloration of the water from time to time

contact Nuvia® Water Technologies with

your model number to order replacement

media.

Table of Contents